Wired2Serve Blog

Wiredblog_waycornerpatch_-_Copy

4 Ways to Kill a Boat's Electrical System, and How to Avoid This.

Posted by K.E. Gregoric on Mar 15, 2016 1:26:48 PM

Out on the water, an electrical failure can be annoying or even outright dangerous. Without electrical power, boats may be unable to navigate, use the radio, or even have lights on. To ensure a good, safe time on the water, make sure to address these factors before they become problems.

 

 



The Wrong Equipment

Simply put, electricity on water is a vastly different proposition from electricity on land. There's a reason an electrical system includes a "ground," after all, but that takes on a very different meaning on the water. Conventional electrical equipment will state there's a good ground simply because current is flowing into the water through the hull or other parts of the boat, for example. So use the right tools, like ohmmeters and voltmeters, for the job.

Similarly, make sure you're using the correct connectors, wiring, and other materials. The land is much more forgiving than the water, and using the wrong materials can blow out fuses, flatten batteries, and in many cases, start fires.



Corrosion

Watercrafts especially are in a constant war with the elements, and corrosion can quickly become your worst enemy. Salt is an obvious issue for seacrafts, of course. But even when sticking to fresh water, the constant humidity and other conditions will take its toll on wiring. And what might happen if a boat gets caught in a storm? Check marine electrical systems for signs of damage before every use, and ensure you'll have power when you need it.


Enjoy the water without worrying about your electrical system.

 


Old Wiring

Another problem, especially on vintage boats, is that the wiring is of a matching vintage. Even the best-kept boat will see some hard wear as it goes on the water, and as wiring ages and takes standard wear-and-tear, it develops more shorts, faults, and other issues. Before taking on the responsibility of a weathered boat, go through the wiring carefully and ensure that it can help you stay afloat in the first place.

 

Mismatched Power Sources

Older boats tend to operate on DC power, while newer ones have incorporated AC, but use direct current from batteries to provide the needed energy. Needless to say, switching from one form to the other, whether through converters or another solution, can put unneeded stress on a boat's electrical system, triggering breakers, knocking out entire systems, and generally causing havoc.

While less of an issue for newer boats, if an older boat has flickering lights or can only accept one item on at a time, look closely at the system for mismatching and other problems, especially as a poorly connected power converter is an ideal place for more complicated electrical problems to develop. And even on newer boats, make a point of looking closely at the grounding on your converter setup; stray AC current "leaking" into the DC ground system can be dangerous.

Boat operators should always make a point of going through and checking the wiring closely. Even a small body of water can be deeply unforgiving if power is lost at the wrong time. And if you need quality parts, start with our wire and cable products.

Topics: How To, Resources & Tools, Marine


 

Wired2ServeBlog_Subscribe-2.jpg

Subscribe to Email Updates

About the Wired2Serve Blog

"Wired to Serve™" is more than just a saying to us. It's who we are, how we live and everything we do, from the way we answer your call, to the products we stock for you.

In this spirit of service, we launched the Wired2Serve Blog to share industry news, helpful advice and other insider info to make your workdays easier and more enjoyable.

Keep your finger on the pulse of the 12-volt electrical industry - subscribe below and be the first to know when new articles are published.

Know that we would never sell or trade your personal info and promise not to spam you either - we know you're far too busy for that.

Subscribe to the Wired2Serve Blog